SEH System - Pull & Splice Connection System, Crimping tool

Sertifikaadid

Max. Temperature range
-60 ?C to + 260 ?C (see data sheet)

Kirjeldus

Typically long line pipe work and heating elements are located in areas where access is limited. Solutions with Pull & Splice Boxes for SEH system heating cables and heat tubes are mainly an auxiliary device to pull and install the BARTEC SEH Skin Effect Heating cable into the metal ferromagnetic tube. The connection meets the requirements current leading, water resistant insulation, dielectric strength insulation and handling.

BARTEC recommends following the regional and international standards to indentify hazardous working conditions by exposure to high voltage. The design and the work on site must always observe safe handling conditions.

Crimping tool

The mechanical crimping tool is used for compression butt connection. With the set cable can be connected at join with each other or inside the power feeding or end boxes.