LMP Loudspeaker Mute Port

Certificates

-20 ?C to +50 ?C

Description

The BARTEC VODEC Loudspeaker Mute Port disables loudspeakers in the vicinity of a live operator VAP30/VAP01 microphone access panel to prevent the detrimental effects of acoustic feedback. The unit is designed for snap on/off industry standard DIN rail mounting and comprises of a robust glass fibre printed circuit card which is equipped with 100/70Volt line plug/socket input terminations and ?controlled loudspeaker? circuit output terminals. The loudspeaker mute port is intended to be located in the PAGA central equipment system MDF or termination compartment. Up to four discrete muting outputs can be driven from any VA300+ amplifier CAGE without recourse to additional hardware fitted (each corresponding to operator access unit input in to the BARTEC VODEC VX/AT central PAGA processor). The unit incorporates an engineers switch bank that allows selection of high or low priority access inputs. Muting can be derived from any VA300+ amplifier fitted within a VA300/CAGE to ensure that the mutable loudspeaker resides in the correct zone of address for the particular site PAGA configuration. This is engineer selectable by an on board plug link patch field which enables any mutable loudspeaker circuit assignment without rack wiring or alteration.

Muting is actioned under control of the VX/AT switch, via a flat insulation displacement ribbon cable, which enables multiple Loudspeaker Mute Port to be cascaded without additional cubical wiring. Mutable loudspeaker control is managed by high reliability fail-safe, (normally deenergised, energised to ?mute?) sealed relays. Line output terminations to the individual mutable loudspeakers each incorporates a test connect/ disconnect switching feature to allow the engineer to isolate line(s) during maintenance/commissioning operations. It should be noted that each host VA300+ amplifier is capable of supervising up to eight loudspeaker circuits enabling mutable loudspeaker lines to be included in the automatic monitoring scheme if required. In this case mutable loudspeakers require fitting of EOL02 or EOL04 end of line supervisory devices.